Selling Victron Energy products

Selling Victron Energy products
Selling Victron Energy products
Showing 1–16 of 66 results
The AC Current sensor is a simple external current sensor used to measure AC Current, Power (VA) and calculate energy of a PV Inverter connected to the AC input or output of a Multi or Quattro. These values can then be displayed and sent to the VRM-website by the Color Control. The two measurement wires can be connected to the AUX and/or temperature sense input of a Multi or Quattro.
The Battery Alarm is a small and low-cost alarm panel which monitors your battery bank. It features both audible and visual alarms, as well as a potential free contact with normally open and normally closed contacts. Alarm thresholds and hysteresis are programmable by DIP switches. See manual for more information.
![]() |
Specs sheet |
A 12V BMS that protects the alternator (and wiring), and supplies up to 200A in any DC load (including inverters and inverter/chargers).
![]() |
Spec Sheet |
The wifi wireless dongle (long range module) connects your Color Control CCGX to your router and transfers data for monitoring to the Victron VRM website. This dongle is for longer distances to your router. Short range, see short range module details. Monitor and manage your Victron Energy system.
Current Transformer 100A:50mA for MultiPlus-II / MultiGrid-II to implement PowerControl and PowerAssist and to optimize self-consumption with external current sensing. Maximum current: 32A.
The ET324 (for three-phase max. 65A) Energy Meters are typically used in an Energy Storage System. To measure the power and energy of the whole application at the distribution box. Or to measure the output of a PV Inverter, to display the data on the Color Control GX and the VRM Portal.
The ET112 (for single phase max. 100A) Energy Meter are typically used in an Energy Storage System. To measure the power and energy of the whole application at the distribution box. Or to measure the output of a PV Inverter, to display the data on the Color Control GX and the VRM Portal.
The ET340 (for three-phase max. 65A) Energy Meters are typically used in an Energy Storage System. To measure the power and energy of the whole application at the distribution box. Or to measure the output of a PV Inverter, to display the data on the Color Control GX and the VRM Portal.
Phoenix converters can communicate with a computer through their RS 232 communications port. All you need to connect your PC, in order to set up and read all the parameters, is the data connection kit as shown.
Use the MK3-USB to connect the following products to a computer for configuration:
The Ion Control shows all vital data from the Lithium Battery system:
• Battery voltage (V)
• Battery charge/discharge current (A)
• Ampere-hours consumed (Ah)
• State of charge (%)
• Remaining time at the current rate of discharge until the battery has reached 90% discharge
• Visual alarm: almost charged, almost discharged
![]() |
Ion Control |
The Li-ion Battery Tower fits four Lithium batteries 60Ah or 90Ah and a VE.Bus BMS. Wiring for 25,6V or 51,2V is included. The VE.Bus BMS and batteries are not included.
MPPT Accessory
![]() |
Quick Install Guide |
![]() |
Dimensions |
MPPT Accessory
![]() |
Quick Install Guide |
![]() |
Dimensions |
Smart Battery Sense is a wireless battery voltage and temperature sensor for Victron MPPT Solar Chargers.
With voltage and temperature sense in place, batteries will be better charged; improving charging-efficiency and prolonging battery life.
Both for lead, and for lithium batteries.
![]() |
Manual |